MNATS REV A REV A #101-125 REV AB #125-216 REV B #217-1078 NOTES
GC AMP
R37 470K 560K 470K 470K
R42 182K 180K 180K 180K
R43 38K3 47K 47K 47K
R45 OMIT 560K (Confirm) 220K  220K 220K T&C Parallel across R43 (47K), Combined value = 38K3 which is the value of MNATS R43.
R46 47K 22K 47K 47K
R47 44K2 47K 47K 47K
R48 7K68 8K2 8K2 8K2
R51 4K7 8K2 4K7 4K7
ATTACK POT
R54 470R 620R  1K2 470R
C27 .022uF OMIT .012uF  .022uF
RATIO
R58 180R 3K9 180R 180R
R63 1K5 2K7 1K5 1K5
R22 56K 56K 47K 47K  
R19 130K 130K 68K 68K NOTE: If you're using the great Hairball PCBs R19 is marked as R8 on the documentation
R78 JUMP JUMP 47k 47K NOTE: R78 is marked as R10 on Hairball PCBs
R64 2K2 1K2 2K2 1K5 Mnats listed 1K2 in PDF, but is labeled 2K2 on board
QBIAS
R60 3K9 JUMP 620R 3K9
R85 JUMP JUMP 1K 620R To Rev B spec
SIGNAL PRE-AMP
R6 560K 560K 2M2 Second FET was dropped in REV B in favor of a 1 FET, 2 Transistor pre-amp 
R7 560K 560K 2M2
R11 10K 10K 9K1
R12 1K 1K 2K2
C3 6.8uF 6.8uF 6.8uF The schematic appears to show 6.4uF here, 6.8uF is the nearest value
R16 47K 47K 100K
C6 33pF 35pF 68pF (Parallel R7)   C22 was moved to R7 from R16 on REV AB
R17 8K2 8K2 4K7
LINE AMP
R31 OMIT OMIT 3K9 10K (Confirm) This mod adds a resistor (3.9k) in series with a capacitor (1000pF) and it should be 
C13 OMIT OMIT 1000pF 270pF connected from the (-) of C9 to the junction of WHTRED - R32 (See Line Amp Mod Diagram below)
C9 47uF 6.8uF 6.8uF OMIT Not sure where version 47uF comes from, could be an oversite
C11 47pF 47pF 10pF 10pF
R30 120K 120K 150K 150K + T&C Parallel
GR METER NULL ADJ
R74 1K 1K JUMP
R76 8K2 18K or 10K? 18K or 10K? 8K2 Need to verify 18K or 10K for REV A,AB
Compiled by Mplancke Dec/2009
Modified Jan/2010, signal pre-amp values added
Jan-09-10: Added Line Amp values and more signal amp values per Neeno on Prodigy Pro
Jan-10-10: Added Rev A/AB Ratio Board diagram, NULL ADJ Info revised
LINE AMP MOD
RATIO BOARD MOD